Central unit Q20, Controller for underfloor heating and radiators through distributor, 8 zones
Additional Quicksmart Q20 controller, works only together with Q20 and e-Hub thermostats
You can customize your system starting from the basic Q20 kit with 4 thermostats; Additionally, Q20 Thermostats and Q20 Controllers can be added
Quicksmart Q20 central unit functions:
- Wireless connection of two Q20 controllers, with a receiver (house with floors)
- Wired connection with the central unit (if you do not opt for Wireless)
- Wireless connection, without wires with room thermostats
- It is mounted on any distributor, floor heating or heating with radiators
- Selectable from thermostat, Warm or Cold mode for heat pumps
- Allows the connection of the same thermostat on several zones, maximum 8 thermostats and 8 zones
- Selectable NO or NC actuators, can work with up to 32 thermal actuators
- Boiler and pump delay time adjustable, 0-6 minutes
Part of the Q20 automation system. image for presentation
Technical data of the Quicksmart Q20 central unit:
- Power supply: 230 VAC, 50/60 Hz
- Circulation pump output: 230V
- Frequency: 868Mhz for thermostat connection
- 8 zones (5 actuators/zone)
- Boiler output: voltage-free output
- Max. Current: 5A for each output
- Can be used with NC (Normally Closed) or NO (Normally Open) actuators
- Dimensions: 353.5mm x 118.4mm x 59.5mm.